Waves Parametric Convolution Reverb IR-L Guide de l'utilisateur télécharger pdf (Page 34)

Loading Impulse Responses

The IR-1 load menu is the same load menu used in all WaveSystem plug-ins. Use

“Open preset file…” to load a Waves setup file *.xps. Use “Import Impulse Response

from WAV...” to import IR’s either from standard .wav files or from Waves Impulse

Response (.wir) files.

Under “Factory Presets” you can select “IR-1 Full Reset…” to load the default IR, “Hall -

1”, by choosing “Impulse Response and Reset”. This loads the IR and resets all plug-in

settings to the factory defaults. You can also choose to load just the default IR by

choosing “Impulse Response”. This leaves all other parameters unchanged.

Full Reset sets the plug-in to a flat setting that allows for auditioning the original

Impulse Response, with two exceptions:

• The Direct On/Off switch will be set to “Off”. To audition pure convolution, you

will need to set it to On, unless the control is disabled.

• The Wet/Dry slider is untouched by the Full Reset factory preset. To audition

pure convolution, make sure it is set to 100% Wet.

Note that for most studio work, you should use the IR with auto-removal of its acoustic

direct portion (set Direct to Off) and with the dry signal replacing the acoustic direct.

Waves IR-1 software guide page 34 of 40

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Waves Parametric Convolution Reverb IR-L Guide de l'utilisateur Page 34